Use instructions for Diera Color

DESCRIPTION
It's a paste made in some colours to rejoint any kind of ceramic pieces for inside and outside.
To fill in joints over 1mm of width.

HOLDER
The joints should be clean, without oils, inks or dust.
When the ceramic is absorbent or with an irregular side a protector must be applied.
The surface of the ceramic must be clean before the application.

PREPARATION
Mix the powder with approximately 25% to 28% of water
Make homogeneous until it gets a thick paste
Apply immediately
Do not use too much water

APPLICATION
Spread the paste with a rubber darby on the diagonal direction of the joints. Press well
You can use application gun
The application on small areas is recommended
Do not apply with rain, low temperatures, direct sunlight or high temperatures
After the application wait for about 50 to 100 minutes to solidify

CLEANING
Clean with an absorbent sponge
Do not use too much water during the clean up
The excess of powder will be eliminated with a dry cloth

COMPOSITION
White cement TP BRII 32,5 R
Micronised calcium carbonate
Inorganic additives
Mineral pigments
Plastic resins

STORAGE
Dry and ventilated place, on pallets and packages hermetically closed.


Retrieve login